TEC-2 Winder

The revolutionary design of the TEC-2 simplifies center winders by eliminating the turret. The lay-on roll moves between stationary shafts for quick cut/transfers. Additionally, the TEC-2 can be outfitted to comply with ergonomic requirements by integrating a swing-out hoist shaft extraction and roll-handling unit that reduces operator lifting requirements. The overhead hoist shaft pivots the roll out of the winder and a shaft puller removes the roll, eliminating the operator's need to lift. In addition to the roll unloading capabilities, this winder is a compact, low-cost alternative for processors.

Highlights of the TEC-2:

• Capable of winding at 300 fpm (91 mpm).
• No turret center winder.
• Automatic cut and transfer in two directions.
• AC flux vector drive system.
• Available in widths from 40 to 80 inches (1,016 to 2,032mm).
• Integral shaft pulling.
• Dancer controlled, AC flux vector drives.